AM-75-3 Shampoo Bed

AM-75-3 is a 2180 x 880 mm shampoo bed with the platform at 630 mm, upholstered in grey leather-look fabric. Bowl, padded neck rest and brass faucet sit in a black head-end module that carries the control panel; the rest of the top is one flat pad.

Footprint and station planning

2180 mm is the longest body we build: two along one wall take 4360 mm before any gap, and covers made for 2000 mm stop short at both ends. The bowl is built in, so hot and cold supply and the drain land inside the head-end footprint, not on the wall — settle the pipe runs before the floor is screeded, or the trap ends up under the base. The panel is wired into the module, so put a power point at that end too. Because the therapist works at the bowl, the head end needs standing room — this bed cannot go hard against a wall there, the reverse of a treatment bed. At 630 mm a client sits on the edge and swings up; the bowl sits low enough that the therapist’s hands are not at chest height.

Where this shampoo bed is used

For rooms selling wash, scalp and head massage as one service: the top is fixed flat, so there is no backrest to reset between services. The padded neck rest carries the neck instead of the bowl rim, which is what stops a ridge across the back of the neck after a long wash. The cover is leather-look, so water beads and wipes rather than soaking in. A bowl at the end also frees both sides — no basin cart to walk around — while the client’s arms stay on the pad, not on a rim. Where the same platform should run without a bowl and with a hand rest instead, the AM-75-2 is that bed. Where the same 880 mm width should come 180 mm shorter in caramel and cream, the AM-75-6 is the 2000 mm version. Where the same 630 mm height is needed on a longer 2250 mm body at 750 mm wide, the AM-803 is that shampoo bed.

Customization and finishes

Cover colour, panel tones and faucet finish are chosen per order against a colour reference; the basin module and bowl stay black. The bowl is fixed at the head end, so the side the water enters from is settled at order. Send a colour reference and the target dimensions and the reply confirms what is buildable plus the MOQ.

Ordering, MOQ and lead time

MOQ, packing, lead time and warranty are settled per order and written into the contract. The bed ships as one piece and 2180 mm is an oversized load: give us the door width, lift dimensions and stair turn, and tell us the water pressure and voltage. The range is listed in the shampoo bed collection, and wet-area clearance is covered in our note on station spacing, and how much floor a treatment bed needs around it is set out in our massage bed buying guide.